Product description
The float switch with changeover contact (NO/NC) is suitable for all types of water, such as tap water, rainwater, wastewater and various other liquids or chemicals (not for diesel and oil). The mounting height (position) determines the switching point of the float switch.
Applications
- Level detection of non-conductive water (demi water)
- Alarm notification for basin when water rises above or falls below a certain level
- Potential-free switching contact for liquid level for control system
Float sensor for alarm unit
This robust float switch can be connected to alarm units, instead of a water sensor or detection tape. This float switch has a changeover contact, for NC (normally closed) and NO (normally open) and can be connected directly to a
GSM detector. As the water level rises, the float housing floats and the changeover contact switches. The float is equipped with a sturdy 3-wire signal cable, which may be extended up to 50 m. Please note that the potential-free contact is not suitable for switching mains voltage.
Specifications
- Detection principle: elevation sensor
- Execution: waterproof float
- Mounting: horizontal/ lateral
- Material: polypropylene
- Material O-ring: silicone
- Operating temperature: -10...+80 °C
- Type of switch: reed contact
- Changeover contact: NO + NC
- Switching current: < 0.25 A
- Switching voltage: < 50 V
- Switching power: < 3 W
- Length: total approx. 81 mm
- Float body: Ø 18 mm
- Up/down movement: 43 mm
- Fastening: nut M16
- Manufacturer: Euroswitch
- Cable length: approx. 200 cm
- Cable diameter: Ø 5 mm
- Weight: approx. 24 g
- Quality mark: CE
*Please note that a basic knowledge of electrical engineering is required (for installation) when purchasing some products on our web shop.